- Should I switch my geyser off?
- Does a condensate drain need a vent?
- Do all toilets have an overflow pipe?
- What are the signs of a burst geyser?
- What size is overflow pipe?
- How do I know if my pressure relief valve is bad?
- Why does my hot water heater overflow keep discharging water?
- What happens when condensate line is clogged?
- What is the pipe dripping water outside house?
- What causes the geyser to overflow?
- How do I fix a leaking pressure relief valve?
- What is a toilet overflow pipe?
- Are unvented hot water cylinders safe?
- How do you adjust a hot water pressure relief valve?
- Should air be coming out of my condensate drain line?
- How do I stop my hot water cylinder from overflowing?
- Do modern toilets need an overflow pipe?
Should I switch my geyser off?
According to most professionals, including Eskom’s Geyser Fact Sheet, turning off your geyser will not save much electricity.
For 24 hours after your geyser is switched off, only 10°C of the heat is lost.
By the same token, permanently keeping your geyser on won’t save any more electricity either..
Does a condensate drain need a vent?
In an AC drain, the condensate pan is the vent. No additional vent pipe is required. The line should continually slope down to the outside.
Do all toilets have an overflow pipe?
A modern toilet will have an internal overflow Flush Valve fitted, which is great as it removes the unsightly overflow pipe and saves drilling a hole in your house for it. But it does mean you need to look out for the signs that your cistern is overfilling.
What are the signs of a burst geyser?
Obvious signs are excessive water leakage through the overflow or hot water and/or steam escaping through the pressure-control or temperature safety valves. Ignore these signs and you might end up with a burst geyser.
What size is overflow pipe?
19mmThe overflow pipe itself should be: At least 19mm in diameter.
How do I know if my pressure relief valve is bad?
Signs Your Pressure Valve is BadFlooding: Water should never be gushing from the valve. … Excessive noise: If your water heater is rattling or emitting a high-pitched whistling noise, it’s likely the sound of steam trying to escape the tank, which is a sign of far too much pressure pressing against the inner walls.More items…•
Why does my hot water heater overflow keep discharging water?
Since water expands as it’s heated, higher-temperature water occupies more volume, which, in the confines of a water heater, results in increased pressure. If the pressure increases too much, your relief valve will activate, releasing water through the drain pipe.
What happens when condensate line is clogged?
A clogged condensate drain line will trap water in your air conditioner. As a result, the evaporator coil will eventually turn to ice. The moisture in the drain line can also freeze, which will cause your air conditioner to turn off. But before it does, it’ll likely suffer some damage.
What is the pipe dripping water outside house?
The two most common drain pipes that most people have on the side of their house are air conditioner condensate lines (AC drain line) and water heater pressure relief valve lines (PRV drain line). Let’s talk about each separately as this is the quickest way to know if your water leak is normal or something urgent.
What causes the geyser to overflow?
If hot water and steam are coming out of the overflow pipe, it may indicate a release of the safety valve because of excessive temperature or pressure. The most common cause is a faulty thermostat. … If your geyser bursts or springs a major leak, the drip tray might not be able to cope with the gushing water.
How do I fix a leaking pressure relief valve?
When a temperature and pressure (T&P) relief valve at a water heater leaks, it’s usually a simple fix; just replace the valve. These valves cost less than $15, and replacing the valve is a very basic job – just drain some water out of the water heater, remove the discharge tube, and replace the valve. No big deal.
What is a toilet overflow pipe?
Overflow tube: This keeps excess water from overflowing into the tank and spilling onto the bathroom floor. It is connected to the flush valve. Supply line: This connects the water supply to the toilet, usually at the base of the toilet tank, and allows for proper flushing. It includes a shut-off valve.
Are unvented hot water cylinders safe?
Unvented cylinders are designed to withstand considerable internal forces and are extremely safe to use when fitted with all the correct pressure equipment. They are usually made from stainless steel due to the high tensile strength that can be achieved from a fairly thin sheet.
How do you adjust a hot water pressure relief valve?
Loosen the lock nut on the pressure reducing valve with a wrench and back it off by unscrewing it. Fit a socket wrench over the adjustment nut on the top of the valve. Turn the nut counterclockwise to reduce the pressure downstream from the valve and clockwise to increase it.
Should air be coming out of my condensate drain line?
You can expect cold air to come out of the T. It is tied into the A/C unit and takes the condesate from the cooling coils to the drain. So the drain it open to the samy system h air is cooled in..
How do I stop my hot water cylinder from overflowing?
Find the PTRV valve on the side of the cylinder near the top or bottom, then lift the silver lever three or four times to open, close and clear any blockages. If the water flow comes to a stop then your problem is solved. But if it keeps running then you probably need to replace the valve.
Do modern toilets need an overflow pipe?
Modern toilets do have an integral overflow, it’ll go straight into the pan under fault conditions. The external overflow is surplus to requirements, feel free to remove and fill hole if you so desire.